Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Info reqd on Trace command

Hi

is ther anyway to change the packet size of tracert command being used from command prompt of our PC??we can use different byte size for pinging is ther any options available like that to change the packet size.

prem

2 REPLIES
VIP Purple

Re: Info reqd on Trace command

Hi Prem,

AFAIK this is not possibe. Just out of curiosity, why would you want to change the packet size of the trace ? What do you want to accomplish ?

Regards,

Georg

Re: Info reqd on Trace command

hi george

we hve put route map in place in all interface due to which i m unable to trace some of the customers lan ip.since i m doing this from my pc and not from my routers always.though pc is using 92byte packet for trace its getting blocked whenever i trace.to avoid the same i need to increase the byte size and chek.

prem

105
Views
0
Helpful
2
Replies