Installing 1FE2W module in a 2613

Community Member

‎06-25-2002 02:17 PM

I have read some literature which suggests that the 1FE2W module for the entire 2600/3600 series of multi-service routers, but can't find anything which specifically mentions that this can be installed in a 2613 router.

Labels:

Other Network Infrastructure Subjects

1 REPLY

N/A

‎06-25-2002 02:17 PM

This router does not support NM-1FE2W.

If you need 2 WAN ports, NM-2W is accepted by 2613.

Latest Documents

PFRv3 channel state questions

Created by Vasilii Mikhailovskii on 04-23-2018 05:06 AM

This document gives several answers on frequently asked questions for PFRv3 channel state behavior. Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st... view more

VPN and static NAT problem

Created by Jacopo Belcredi on 04-23-2018 04:07 AM

Symptoms The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921). The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN. I couldn't connect to the hos... view more

Cisco ESW-520-24P Switch Configuration

Created by Kevin DeMott on 04-19-2018 01:49 PM

We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des... view more