Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Installing new PVC on Frame Relay Network

Existing setup: A wan Frame Relay network through a providoe (Sprint) in which sites A and B are the hosts for several remote offices C, D, E, & F.

All PVC's are configured between Sites A and B and the rest of the remote offices (Meshed network).

There is a need to connect two of the remote offices C and D directly to access resources between each other.

Can we configure just two new PVC's between C and D through the providor ? or We need to upgrade one of them to be a third host ?

Any input for this question is highly appreciated.

Thanks

2 REPLIES
Bronze

Re: Installing new PVC on Frame Relay Network

Hello,

You can order a PVC directly between sites C and D. However, you should be able to route traffic between these two locations via the PVCs you already have, to sites A and B. Of course, this would depend on the amount of traffic you need to send between these two sites.

HTH,

Mark

Re: Installing new PVC on Frame Relay Network

You can just order a new pvc for the sites C and D. You dont need to upgrade one of them to a new host.

102
Views
0
Helpful
2
Replies
CreatePlease login to create content