Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

int ATM WS-X2961-XL for 2924M-XL-EN

hello,

I use a switch 2924M, with an interface ATM WS-X2961-XL . With the boot I do not see in the show version the interface ATM.

when I return in configuration mode, I nothing commands on the level interface ATM.

I think that I am not with the good versions of code on the level of the 2924m-xl frame.

Code 2924M:c2900XL-c3h2s-mz.120-5.WC3b.bin code ATM sloT 1: c29atm-m-MX-120.7-XF.bin

sh ver :

Switch>sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2900XL Software (C2900XL-C3H2S-M), Version 12.0(5)WC3b, RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Fri 15-Feb-02 10:14 by antonino

Image text-base: 0x00003000, data-base: 0x00337600

ROM: Bootstrap program is C2900XL boot loader

Switch uptime is 53 minutes

System returned to ROM by reload

System image file is "flash:c2900XL-c3h2s-mz.120-5.WC3b.bin"

cisco WS-C2924M-XL (PowerPC403GA) processor (revision 0x11) with 8192K/1024K bytes of memory.

Processor board ID FAB0621Y1M9, with hardware revision 0x03

Last reset from warm-reset

Processor is running Enterprise Edition Software

Cluster command switch capable

Cluster member switch capable

24 FastEthernet/IEEE 802.3 interface(s)

32K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address: 00:09:B7:CD:0A:C0

Motherboard assembly number: 73-3425-10

Power supply part number: 34-0920-01

Motherboard serial number: FAB062150ID

Power supply serial number: PAC051701B1

Model revision number: A0

Motherboard revision number: F0

Model number: WS-C2924M-XL-EN

System serial number: FAB0621Y1M9

Module Ports Model HW Version SW version

------ ----- ----- ---------- ----------

1 1 WS-X2971-XL 0 12.0(7)XF

Configuration register is 0xF

1 REPLY
Cisco Employee

Re: int ATM WS-X2961-XL for 2924M-XL-EN

Are you able to session into the ATM module by issuing a "session 1" command?

200
Views
0
Helpful
1
Replies
CreatePlease to create content