I am trying to set up an 871 router (1 FE WAN port, 4 FE LAN ports as an integrated switch) for a small business with classic internal, perimeter back rail, and perimeter front rail networks. Each of these networks is currently set up on a segregated, unmanaged switch. I'd like to use the VLAN function to segregate traffic from each of these switches through the LAN FE ports with ACL's to control the traffic as it comes together in the router part of the 871. Can anyone point me to sample of the statements required to set up this config? I know one thing is that I'll need the get the Advanced IP feature set to allow me to create more than the single administrative VLAN1. Also, how do you set up the trunking and subinterfaces. Is that done on a BVI interface?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...