I have offices at three different locations in same city. At all the three building I have installed Ericcsion Digital Exchange (EPBAX) whereby my employees can get start conversation by dialing the extension only. So virtually its single Office. Now I want to install mail server at one the campus. Since my building are not networked right now I want to integrate Cisco AS-5800 with one of my exchange using PRI channels. So that my any of the employee could get connected with the mail server by dialing one number that may be "nnnnnnnn" (any int.) and download their mails.
Secondly as AS-5800 comes with voice port, I would like to use VoIP feature also.
Any suggesstion (from where and how should I start and so on) / query in this regard would be highly appreciated.
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml
If anyone else in the forum has some advice, please reply to this thread.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.