Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Integration Issue with 3Com switch

Hi,

I am connecting a 3Com 4900 switch to Cisco catalyst 4503 on a fiber- 1000 Base-SX module both sides.The moment I am Connecting the fiber link to the Cisco 4503 , I am not getting any Link ( Link LED not glowing).However this 3com switch is working with the other 3com switch without any problem.Is there any compatibility issue?

2 REPLIES
New Member

Re: Integration Issue with 3Com switch

You should check in the product support page first to check if they are compatible

Green

Re: Integration Issue with 3Com switch

Have you tried reversing the fibers (the TX on one side to the Rx on the other)?

Make sure the SX module is well-seated on the Cisco side.

Are you using the same jumper / link to connect the Cisco as you are the 3COM? Have you tried other jumpers/links?

Make sure the connectors and ports are clean.

Make sure all other protocols are off (trunking/ redundancy, etc) on both sides.

Can the Cisco connect to ANYTHING from that port (maybe the module is dead)?

Good Luck

Scott

118
Views
0
Helpful
2
Replies
CreatePlease to create content