I have connected quite a few Intel teams into Cisco Cat switches. It depends on what type of team you are configuring- earlier versions of Intel ProSet teams were Adaptive Load Balancing (ALB), Adapter Fault Tolerant (AFT), or as mentioned in the other reply, Ether Channel. If you config either ALB or AFT, you can simple plug these two teamed interfaces into a common switch fabric. One of the NIC's will be deemed as the Primary, and only its MAC address will be used, so as far as the MAC address or CAM table is concerened there is only one interface. The other alternative is to config EtherChannel as described in the other reply- it works great.
here is the link which tells about the teaming option with compaq, hopefully it is same with intel.. But if you are talking about switch fault tolerance, the only thing you have to do on the cisco side, is to configure the etherchannel/portchannel as mentioned earlier in the reply.. ;
I simply use EtherChannel on the Cisco switches and this works perfectly in my network. That is I have both redundancy (at the NIC level) and at the same time produce more throughput. On top of teaming the adapters/switch ports, you can also turn the the "virtual" team into a "trunk" interface. If this is one option you want to do then email me on firstname.lastname@example.org and I'll let you know more about some limitations.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.