The Interface is fastethernet. My main problem is that I need to encapsulate the subinterface with dot1q which is for IEEE802.1q. but there is no encapsulation command at the interface and subinterface. If I don't encapsulate there is now way the sub interface will knew the vlan that is routing for, neither can I assign IP address to the subinterface. My ios version is 12.2(1a).
To enable the inter-vlan routing (ISL or DotQ) on C2600, you must have at least C2620 model with at least IP Plus (!) Feature set IOS istalled. IP-only version does not enable this functionality. What is your version ? (show ver, show flash). See also the Feature Navigator for Cisco IOS tool on CCO TAC (http://www.cisco.com/cgi-bin/Support/FeatureNav/FN.pl).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.