Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

inter vlan routing

hello

i have a cat 6506 layer 3 switch with Gbps ports (optical fiber): no 10/100/1000 RJ45.

i connect this switch with a HP4000M (layer 2 switch) using one of the OF port.

i created many layer 2 VLAN in the HP4000M and use the tagging between the 2 switches. each VLAn is an IP subnet.

can the cat6506 route between these VLANs that r located physically in the HP4000M?

if yes, could you give a sample config of such scenario?

thx

  • Other Network Infrastructure Subjects
1 REPLY
Cisco Employee

Re: inter vlan routing

If you have an MSFC in the chassis, then yes you can configure routing on the 6500 between the different VLANs.

Have a look to http://www.cisco.com/warp/customer/473/#Layer-Three

88
Views
0
Helpful
1
Replies