ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
BOOTFLASH: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOF)
MRR001X uptime is 22 hours, 16 minutes
System returned to ROM by power-on
System restarted at 15:17:01 bst Wed Jul 24 2002
System image file is "flash:c2500-p-l.120-7.T.bin"
cisco 2500 (68030) processor (revision N) with 6144K/2048K bytes of memory.
Processor board ID 06099777, with hardware revision 00000001
X.25 software, Version 3.0.0.
Basic Rate ISDN software, Version 1.1.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
1 ISDN Basic Rate interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
One problem is that the dialer interface is not dialing out when I ping an ip address on the main site from the remote site after having shut down the frame relay serial interface (administritively). I have tried pinging directly from the remote router and the dialer interface is not dialing out. The bri interface is working as it brings itself up to connect to the ntp server every couple of minutes (which is another problem).
The floating static default route is shown in the route table after having shut down the serial interface along with the subnets of the ethernet and dialer interfaces (and all the eigrp routes disappear).
If i do a debug dialer packets i see the following:
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...