all,
I have a sub interface that was inadvertently set to multipoint. When I attempt to change the setting, I get the message below.
interface Serial1/0.6 multipoint
myrouter(config)#int 1/0.6 point-to-point
% Warning: cannot change link type
When I tried to delete the interface, I received the message below. And, when I recreated the interace, it set me right back to mulitpoint.
% Not all config may be removed and may reapear after reactivating the sub-interface voice port 5/0:1 busyout on serial1/0.6 is deleted
ideas?
thanks a lot!