Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

interface load on C6K CatOS

Hello,

just a short question regarding the CatOs running on Catalyst 6000 family. Currently we use RRD tool and MRTG to measure the IOS switches and routers port utilization. Very useful and spectacular. We are going to deploy Catalyt 6509 switches with CatOs and I'm interested if these tools can measure the CatOs port utilizations or not? In the CatOs there is no show command that outputs that interface load. Can we measure it and display it similar to IOS? When yes, which MIB should be quired?

Regards,

Balázs

1 REPLY

Re: interface load on C6K CatOS

Hi,

the only I've found is following:

http://www.cisco.com/warp/public/477/SNMP/calculate_bandwidth_snmp.html

Hope it helps a little,

Milan

303
Views
0
Helpful
1
Replies