Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interface Loopback0 on 29xx switch

I have 2924-XL series switches running 12.0(5)XU catos code. Is it possible to configure a loopback0 on these switches? Setting the snmp logging-source as loopback0 returns the message "Loopback0 not configured", but it then accepts the command. There is no option for configuring this interface through the interface command.

1 REPLY
Cisco Employee

Re: Interface Loopback0 on 29xx switch

XL switches do not support loopback interfaces. Use the VLAN interface IP address

147
Views
0
Helpful
1
Replies
CreatePlease login to create content