Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Interface output from an Catalyst 3550-12G

I've configured a routed VLAN in a 3550-12G, when I make an "sh int vlan x" there is almost no traffic shown under input/outpur rate. I know that there is a lot more traffic than I see, but why don't I see it??

1 REPLY
New Member

Re: Interface output from an Catalyst 3550-12G

If you are expecting all the traffic in that VLAN to appear there, it won't. It will only show all the traffic handled by this switch on that particular VLAN.

71
Views
0
Helpful
1
Replies