cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
259
Views
0
Helpful
2
Replies

Interface resets

earleyk
Level 1
Level 1

I have a new location that I have just added to our wan. I'm getting an intermittent net connection and have found the serial port that the T-1 is attached has had over 11,000 interface resets and carrier transitions in the 10 days the link has been up.The CSU's are not showing any errors. I can't find any likely causes. Any ideas are appreciated.

2 Replies 2

svermill
Level 4
Level 4

Off hand, my first thought would be to check the timing config. Make sure that someone is clocking the circuit.

ali-franks
Level 1
Level 1

Hi,

Scott suggested the timing, but I was wondering if one end of the link was on fibre and the other a 2Mb HDSL bearer?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco