Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Interface resets

I have a new location that I have just added to our wan. I'm getting an intermittent net connection and have found the serial port that the T-1 is attached has had over 11,000 interface resets and carrier transitions in the 10 days the link has been up.The CSU's are not showing any errors. I can't find any likely causes. Any ideas are appreciated.

2 REPLIES
Community Member

Re: Interface resets

Off hand, my first thought would be to check the timing config. Make sure that someone is clocking the circuit.

Community Member

Re: Interface resets

Hi,

Scott suggested the timing, but I was wondering if one end of the link was on fibre and the other a 2Mb HDSL bearer?

132
Views
0
Helpful
2
Replies
CreatePlease to create content