Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Interface State on Cisco 827H

If I do a show interface Ethernet 0 on a Cisco 827H I see the state of the interface always UP UP even when a have not attached the cable. Could someone tell m if this is normal and if exists some documentation where it is related??

Thanks

1 REPLY
Silver

Re: Interface State on Cisco 827H

Since 827H is a router which works more like a HUB. It has a built-in Hub in it. This is a normal behaviour and there is nothing to worry about it.

88
Views
0
Helpful
1
Replies
CreatePlease to create content