Same ISP, wondering if this can be done: one of our applications has public IP address A.B.C.D hard-coded, which is at the production hosting site. When the corresponding gateway goes down, we'd like possibly BGP to trigger the setup of a static NAT so that all traffic to A.B.C.D is sent to W.X.Y.Z at the disaster recovery site. Can this be done with Cisco IOS? Any information would be greatly appreciated. Thank you.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...