Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

intervlan routing

Hi,

I've the following configuration on a Catalyst 3550 Switch:

interface Vlan1

ip address 170.64.82.7 255.255.255.0

standby 90 ip 170.64.82.3

!

interface Vlan100

description ITMGT-61.160

ip address 10.61.160.2 255.255.255.0

no ip redirects

!

But when I try to ping the 10.61.160.2 on the switch itself it does not respond. When I check the vlan status here it is :

PAL0001#sh interfaces vlan100

Vlan100 is up, line protocol is down

Hardware is EtherSVI, address is 0014.a898.1900 (bia 0014.a898.1900)

Description: ITMGT-61.160

Internet address is 10.61.160.2/24

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

ARP type: ARPA, ARP Timeout 04:00:00

Last input never, output never, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 8

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts (0 IP multicast)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 packets output, 0 bytes, 0 underruns

0 output errors, 3 interface resets

0 output buffer failures, 0 output buffers swapped out

PAL0001#

can you help me to understand what's wrong?

Jorge

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: intervlan routing

Hello Jorge,

you need to either have an active access port (that is, a host connected to a port configured for VLAN 100) belonging to VLAN 100 or an active trunk port carrying VLAN 100 in order to get an up/up status for the VLAN interface, and in order to be able to ping the interface...

HTH,

GP

1 REPLY
VIP Purple

Re: intervlan routing

Hello Jorge,

you need to either have an active access port (that is, a host connected to a port configured for VLAN 100) belonging to VLAN 100 or an active trunk port carrying VLAN 100 in order to get an up/up status for the VLAN interface, and in order to be able to ping the interface...

HTH,

GP

114
Views
0
Helpful
1
Replies
CreatePlease login to create content