Hi,
I've the following configuration on a Catalyst 3550 Switch:
interface Vlan1
ip address 170.64.82.7 255.255.255.0
standby 90 ip 170.64.82.3
!
interface Vlan100
description ITMGT-61.160
ip address 10.61.160.2 255.255.255.0
no ip redirects
!
But when I try to ping the 10.61.160.2 on the switch itself it does not respond. When I check the vlan status here it is :
PAL0001#sh interfaces vlan100
Vlan100 is up, line protocol is down
Hardware is EtherSVI, address is 0014.a898.1900 (bia 0014.a898.1900)
Description: ITMGT-61.160
Internet address is 10.61.160.2/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 8
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 packets output, 0 bytes, 0 underruns
0 output errors, 3 interface resets
0 output buffer failures, 0 output buffers swapped out
PAL0001#
can you help me to understand what's wrong?
Jorge
