I have 2950 with 8 vlans using a dot1q trunk to a 2620 router. I want to enable Access control lists on the router as one of the vlans will be a wireless subnet and I only want to allow that traffic to flow too a single destination. How ever whenever I apply an ACL to a subinterface on the trunk it shuts the whole trunk off.. Anyone have any exp with this or can post a sample cfg.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...