09-21-2006 08:59 PM - edited 03-03-2019 05:10 AM
I just acquired a couple of 2600s with single eth. interfaces. I would like to configure subinterfaces (one for public IP, the other for internal.) However, my current IOS insists that I can not assign IP addresses until I make the main interface a part of an ISL or dotq VLAN. Can someone tell me which feature I'm looking for in the feature navigator? I have a feeling I'm going to need to upgrade my routers from their current 32/8 mem.
-Shikamaru
Solved! Go to Solution.
09-21-2006 09:07 PM
Hi Shikamaru,
You need to have atleast IP PLUS feature IOS on your box to make encapsulation command working on subinterface.
Regards,
Ankur
09-21-2006 09:07 PM
Hi Shikamaru,
You need to have atleast IP PLUS feature IOS on your box to make encapsulation command working on subinterface.
Regards,
Ankur
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: