10-30-2007 07:48 AM - edited 03-03-2019 05:33 AM
By mistake i erased the existing IOS in the Router and Switches off power to router.when i switched it on it didn't boot instead it went to ROMMON mode.
can u suggest how can i load IOS in it now,so that it can boot properly.
10-30-2007 08:17 AM
Hi Susheel,
See if this link helps you. You have to try Xmodem procedure
http://www.cisco.com/warp/public/130/xmodem_generic.html
Some routers also support tftpdnls command in rommon
http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a008009429f.shtml
HTH
Ankur
*Pls rate all helpfull post
10-31-2007 09:07 AM
Hi Ankur,
I guess virtually all routers (1700 and onwards) support TFTPDNLD, however I was wondering why this doc says only 3800?
Regards,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: