Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IOS Loading in a Crashed Router

By mistake i erased the existing IOS in the Router and Switches off power to router.when i switched it on it didn't boot instead it went to ROMMON mode.

can u suggest how can i load IOS in it now,so that it can boot properly.

2 REPLIES
Cisco Employee

Re: IOS Loading in a Crashed Router

Hi Susheel,

See if this link helps you. You have to try Xmodem procedure

http://www.cisco.com/warp/public/130/xmodem_generic.html

Some routers also support tftpdnls command in rommon

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note09186a008009429f.shtml

HTH

Ankur

*Pls rate all helpfull post

Re: IOS Loading in a Crashed Router

Hi Ankur,

I guess virtually all routers (1700 and onwards) support TFTPDNLD, however I was wondering why this doc says only 3800?

Regards,

127
Views
0
Helpful
2
Replies