Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IOS loading Issue

Dear All:

I have a 7609 Router with SUP720 installed in module 5 and I have a CMM installed in module 1.

For Some reasons, bootflash image in the CMM module was corrupted and the CMM module is stuck in ROMMON mode.

I copied the bootflash image in the other CMM module installed in module 2 and I uploaded to my tftp server.

The instruction what I get from the CCO site is for catalyst 6509 switches and not for 7609. I tried different trial and error but I failed.

How can I load the image from SUP720 going to the bootflash of the fatal CMM module.

Anybody can give me the solution.

Thanks.

1 REPLY
Silver

Re: IOS loading Issue

check out the following link on Disaster Recovery for CMM Software Upgrades, hope this helps :

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/prod_module_install_config_guide09186a008014f5b1.html#wp278012

129
Views
4
Helpful
1
Replies
CreatePlease login to create content