Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

IOS upgrade on ASR 1002X

How do I upgrade IOS on ASR 1002X?

 

ISSU or set the boot variable and reload. It is standalone switch no redundant peers available.

 

Current version: asr1002x-universalk9.03.07.03.S.152-4.S3.SPA.bin

Target version: asr1002x-universalk9.03.07.05.S.152-4.S5.SPA.bin

 

License Level: adventerprise
License Type: Permanent
Next reload license Level: adventerprise

 

show redundancy
Redundant System Information :
------------------------------
       Available system uptime = 1 year, 14 weeks, 4 days, 12 hours, 59 minutes
Switchovers system experienced = 0
              Standby failures = 0
        Last switchover reason = none

                 Hardware Mode = Simplex
    Configured Redundancy Mode = Non-redundant
     Operating Redundancy Mode = Non-redundant
              Maintenance Mode = Disabled
                Communications = Down      Reason: Failure

Current Processor Information :
-------------------------------
               Active Location = slot 6
        Current Software state = ACTIVE
       Uptime in current state = 1 year, 14 weeks, 4 days, 12 hours, 59 minutes
                 Image Version = Cisco IOS Software, IOS-XE Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.2(4)S3, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Fri 19-Apr-13 13:40 by mcpre
                          BOOT =
        Configuration register = 0x2102

Peer (slot: 7) information is not available because it is in 'DISABLED' state

Regards,

Raghavendra Somiyani

 

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

If it is a standalone, just

If it is a standalone, just change the boot variable. There is no need of ISSU, there will be always downtime as there is no redundancy.

 

 

2 REPLIES
New Member

If it is a standalone, just

If it is a standalone, just change the boot variable. There is no need of ISSU, there will be always downtime as there is no redundancy.

 

 

It worked. Thanks :)

It worked. Thanks :)

447
Views
0
Helpful
2
Replies