we have several switches 5500s and 6500s with software versions 5.1 to 5.2. Now, we are planning for upgrading the switch sofwtares to IOS 12.2.
One problem that I foresee is that the commands in the old version of software were set-based while the new version understands only the IOS commands. is there any method by which we can upgrade the commands also, i.e. changing from set based to IOS commands.
Are there any other problems that we might face? Please reply.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...