I set up an inbound filter on a router interface for temporary action against a virus, and I know its working because I don't see the packets being forwarded out the serial interface anymore using the ip accounting command. but when i go and enable "ip accounting access-violation" on the inbound interface, and then type "do show ip accounting access-violation", i don't see any packets violating the ACL. what do I need to do to see these packets being filtered by the appropriate ACL?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...