Re: ip address change automatically of 2950 series switch
the switch could be a DHCP client. is the server also setup as DHCP client? The switch is getting the IP from a DHCP server from the DHCP scope. You may assigned an ip address to the switch and not to use the switch autoconfig. for Telnet, you must setup the vty login password in order to use telnet.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...