I have four 2610 routers going in connected by private T1's. What ip address structure do you recomend I use for the T1 side of the router? I was thinking of using 10.0.1.1, 10.0.2.1, 10.0.3.1, 10.0.4.1 but when I put this config into the config maker software it tells me to choose a different subnet. Any suggestions for an ip scheme?
If each router T1 only connects to one other router (ie point to point) at each end of the link use the mask 255.255.255.252. It will only allow 2 hosts per subnet, so one end will be 10.0.1.1 255.255.255.252 and the other will be 10.0.1.2 255.255.255.252.
If they are all to be connected together (ie point to multipoint) you can use 10.0.1.1, 10.0.1.2, 10.0.1.3, 10.0.1.4 with a mask of 255.255.255.248 (allows room for small expansion).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.