Host will have to make network connection first before getting an ip address. You really need VMPS, to assign port to a particular vlan then configure your DHCP scope to assing certain ip address for this vlan. Unless, the host have ip address statically defined, but then there is not feature that will assign a particular port to a certain vlan based on ip address.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.