I have 3 networking devices connected on LAN , one is 3641 , other is also 3642 & third one is RAS, now i have added a specific route in router 1 i.e 10.10.1.4/30 pointing to the ethernet port of router 2 , both ethernet port are running fast switching , but when i check the show ip cache output it is pointing the block of 10.10.1.4/30 pointing towards the RAS , where as when i check show ip route , it shows me the correct route, but i cant ping 10.10.1.5 or 10.10.1.6 from the router 1 , since all the packets for the destination is getting forwarded to ethernet port of RAS, so there is a descrepency in the show ip cache output & show ip route output i have tired to clear arp, clear ip cache, but doesnt help.......if some one can help me on this issue.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...