OK, I don't pretend to be a CISCO expert but this is what I have found:
1. I assume you mis-typed the command to set the interface to use DHCP. It is "ip address dhcp" . Since "ip dhcp address" isn't a valid command, the router would have objected.
2. If not, go to the outside interface and use the right command.
3. Since you are using DHCP, I also assume you are using a high-speed modem of some sort to connect to your ISP. I found that you must turn-off your modem for about 30 seconds and with your router off, turn it back on. After the modem cycles, turn the router on. It appears the mac address of the modem gets tied to the first device's mac address (in this case your Micro$oft box) and won't let go.
4. Subsequent reloads of the router won't require this because it now knows the mac address of the routher. If you go back to the Micro$oft box then do the power-off thing again.
5. Now, if someone can help me set NAT to work with the DHCP client I will be happy. Seems NAT wants an IP or group of IPs to work.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.