I've got a weird situation here. Thought I'd toss it up for a sanity check.
Bringing up a new T1 frame relay line to Branch A (1720 router). Branch A's PVC is mapped to Campus 1 and Campus 2 (2620 routers). (Campus 1 and 2 are functioning normally with several other branches). So far so good. Branch A's S0 interface is up/up, PVC's are up, and is exchanging CDP info with Campus 1 & 2 routers. However, we are not receiving any IP traffic from Branch A.
"Debug ip icmp" issued on all 3 routers. Pings to next hop S0 IP address from Campus 1 or 2 are seen on Branch A. Branch A sends an echo reply out S0, never to be seen at Campus 1 or 2. Have verified the configs and swapped out the router and CSU at Branch A also. Eliminated extended demarc by plugging directly into smartjack. Frame relay provider insists they are not at fault and we're certain it's not the router. Any insight?
can u give a debug frame packet and see, what message is obtained, when u ping Branch A. Make sure, u have a downtime while doing this, as Campus 1 and Campus 2 should not be handling critical traffic, while you issue the debug command.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...