Is there a delay timer available for the IP HELPER-ADDRESS function? I am getting more DHCP leases completed through my relay agent than my local DHCP server. The DHCP server appears to be practically 0% utilization 24/7 so I can't image the relay agent is getting a faster response than the local DHCP box. I would like to add a delay value to the IP HELPER-ADDRESS service so that it does not become the primary method of acquiring dhcp addresses.
I have two subnets/sites that are connected by a T1. In both sites are DHCP servers (w2k server). Each DHCP server has a portion of the other site's DHCP IP addr pool for failover purposes. I am finding that a large portion of the opposing sites IP addrs are being allocated from the failover pool instead of the primary pool on the local DHCP server.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...