I want to translate a local address to a public address. I'm speaking about one concret private address.
I thought in the command 'ip nat inside source address 192.168.64.11 126.96.36.199', but I've got a doubt: to the router can arrive packets with the public address (188.8.131.52) and the private one (192.168.64.11) and the router only has to translate the private and let pass without any change the rest.
The command, does it works in this way? Does anyone see any problem with the configuration?
AFAIK, when you have a statement like that, if the packet is outbound, routing is done first, then translation. If the packet is inbound, the translation is done first, then routing. So if you are dealing with inbound packets arriving on the interface that was defined as "outside", the router will translate the IP 184.108.40.206 back into 192.168.64.11 and then route the packet based on 192.168.64.11.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...