Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IP NAT command error

Hi.

I'm configuring one old 1603, when I insert the command: ip nat inside I obtain: % Invalid input detected at '^' marker.

What is the problem??

Regards.

1 REPLY
Silver

Re: IP NAT command error

what is your code, your feature set most likely does not support nat use this url to determine what code you need

http://www.cisco.com/cgi-bin/Support/CompNav/CN1.pl?HStartForm2=True

101
Views
0
Helpful
1
Replies
CreatePlease to create content