Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
192
Views
0
Helpful
1
Replies

IP NAT translation problem

jsalminen
Level 1
Level 1

‎10-07-2003 10:05 AM - edited ‎03-02-2019 10:50 AM

I've had this router running NAT and PAT (overload) for just about a year. In the past two weeks in two instances I've had to clear translations in order for one of the five sites connected to this router through a WAN to pass through. I'm using nat for an overlapping network addressing problem.

I have four IP addresses allocated to NAT and overload enabled on this pool. In the affected site I only have about 15 servers that connect to the remote site through NAT.

My IOS on the NAT'd router is 12.2.8YJ. I searched the bug toolkit and did not find any relevant issues.

Any assistance is appreciated. TIA

Labels:
0 Helpful
1 Reply 1

bwilmoth
Level 5
Level 5

‎10-17-2003 07:26 AM

This is a IOS bug Problem, This bug is found in earlier releases and has been fiexd in the later version 12.2.13T. Check for the bugs CSCdx82097, CSCdy27354 and CSCds35154.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents