Hi,
I dont think so but you could go round this.
Configure the LAN interface for bridging
and apply the MAC access-list to the incoming ethernet
interface. You then enable IRB and creat an interface BVI
which is which would be the point where bridged ethernet traffic
enters the routed network.
e.g
int ethernet 0
bridge-group 1
bridge-group 1 input-address-list 702
!
interface bvi 1
ip address 1.1.1.1 255.255.255.1 -->an address for the subnets used for host on the LAN
!
bridge 1 protocol ieee
bridge irb
bridge 1 route ip
!
access-list 702 permit 0002.4b00.0000 0000.00ff.ffff
Hope it helps
Regards
oodunuga