Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

IP Policy Route-Map and Cat4000

I am trying to configure a route map on a 4232-L3 routing module at code level 12.0(10)W5(18f). I know this is several revs behind but need to get the route map working asap. I am going to proceed with the code upgrade but does anyone know if this module will support the route map at any code level. I can configure it but I can not apply it to the interface since the interface command is not present.

Thanks,

Greg

2 REPLIES
Cisco Employee

Re: IP Policy Route-Map and Cat4000

Route maps are not supported on the 4232-L3. It is hardware based router similiar to Catalyst 8510 and does not support PBR.

New Member

Re: IP Policy Route-Map and Cat4000

Hey Froom how are things there. This is Greg Parrish. Anyway thanks for the reply, wanted to be sure since I could not find anything in the docs or elsewhere. You know how it is when you are trying to prove something that is NOT a feature. I am trying to migrate traffic from one link to another so I was going for the PBR. Is there another way to do this perhaps based on the source subnet?

Thanks,

Greg

226
Views
0
Helpful
2
Replies
CreatePlease to create content