if only one of your machines is affected, it sounds more like a problem with that particular machine. Can you try and check if the cable is connected properly, and maybe replace the network card on the affected machine ?
It is not only one computer but all the computers above the Ip number 192.168.254.7 and if i change a computer that has problems with an Ip above 192.168.254.7 with for example 192.168.254.6 the problems for that computer are solved but i have 10 computers so i must go above the 192.168.254.7.
The funny thing is that it works for sometimes 10 minutes
did you check your subnet mask configuration of router and pcs? It sounds like you are using a 29 bit mask. It provides you a subnet 192.168.254.0 to 192.168.254.7, with usable addresses 192.168.254.1 to 192.168.254.6.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...