Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ip ssh break-string

Hi,

I'm running IOS c1700-k9o3sy7-mz.123-3.bin IP/ADSL/FW/IDS PLUS IPSEC 3DES on model 1760 router.

The above configuration is inserted automatically into the running config. When the config is saved and the router rebooted, the config line is rejected (but it remains in the running config)

Any ideas?

Thanks in advance

2 REPLIES
Anonymous
N/A

Re: ip ssh break-string

I never find such a command in the config guide or command reference. Not sure why or how you see this.

New Member

Re: ip ssh break-string

I raised a TAC case on this yesterday given no solution from the CCO forum. The Case is E521810 and the initial response from the TAC engineer is the following:

Request for feature was submitted in CSCin46441 - BREAK signal support for SSH . Description : Like telnet SSH doesnt support sending BREAK signal. This is needed when SSH acting like SSH terminal server (reverse SSH). . Request was integrated in 12.3(02.03)B 12.3(01.09)T 012.003(001.009) .

I need to verify if this feature was integrated in 12.3.3 for 1760 let you know the result as soon as possible.

743
Views
0
Helpful
2
Replies