Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ip tunnel

Does anyone know if its possible to increase the bandwidth on an IP tunnel from the default 9k?

1 REPLY
Silver

Re: Ip tunnel

Sure you can. Using the bandwidth command you can change this.

Note: This does not change the amount of data that is allowed to go through the Tunnel interface. If you are trying to shape/police this you'll need to use other means. Bandwith settings on interfaces are more for dynamic routing protocols to decide which link should be placed into the forwarding table.

vxr3(config)#int tun0

vxr3(config-if)#bandwidth 10000

Tunnel0 is up, line protocol is up

Hardware is Tunnel

MTU 1514 bytes, BW 10000 Kbit, DLY 500000 usec,

Hope this helps,

Don

240
Views
0
Helpful
1
Replies