07-24-2002 07:35 AM - edited 03-02-2019 12:08 AM
I have 4 leased line with 4 cisco 2610 with 2 serial.
Encapsulation HDLC, load balancing with EIGRP and failover with MHRSP.
I configured my serials interfaces with ip unnumbered e0/0, so each s0/x obtain ip address from interface ethernet 0/0.
But when i ping a router from another, it fail.
From local network i reach ethernet interface of local router, but not ethernet of other routers.
Why this? I'm missing somethings?
Thanks.
07-24-2002 07:50 AM
Remember you can't ping an IP unnumbered interface.
07-25-2002 07:27 AM
Well, first start with troubleshooting your serial interfaces to make sure you have connectivity between your routers:
http://www.cisco.com/univercd/cc/td/doc/cisintwk/itg_v1/tr1915.htm
Next, troubleshoot your routing protocol:
http://www.cisco.com/warp/public/105/top_issues/iprouting/top_issues_rp.shtml
True, you can't ping your serial I/F, but you should be able to ping eth0 to eth0 on your routers.
Have fun!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: