Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

IPIP tunnel to a HSRP router pair

I need to establish an IPIP tunnel between a single router and a HSRP pair on the other end. How to deal with the tunnel destination address on the single router side and how must be done the whole tunnel config on the HSRP side?

Is it actually possible to configure? Any suggestions? Thanks in advance, Peter

1 REPLY
Gold

Re: IPIP tunnel to a HSRP router pair

I don't think you can configure anm HSRP address as a tunnel endpoint--there's too much state involved, I think (fragmentation reassembly and such). I can understand what you are trying to do--email me directly on this.

Russ

97
Views
0
Helpful
1
Replies
CreatePlease to create content