Im quite new in networking. recently, i have been given a case on ipv6 issue for our client. the ipv6 configuration has been setup at a few related vlan's interface. The issue is, the host device[desktop PC] able to get the ipv6 address as well as ipv6 default gateway, but when check at dhcp server, the ipv6 address for the PC not available - meaning that the address is not assigned by the DHCP server.
below is the sample config at 1 of the vlan interface for ipv6 configuration in the coreswitches for your perusal
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...