03-05-2006 05:56 PM - edited 03-03-2019 02:08 AM
Dear All,
Is Cisco Express 500 switch support 802.1q trunk?
Also, all fastethernet port on CE500 will assign VLAN 10. I would like the switch to allow VLAN 20 and 30 to pass through the trunk? Is it possible?
Thanks.
C.K.
03-05-2006 06:21 PM
Hi,
The CE500s do support trunk interfaces and you can configure them to permit any VLANs as you choose.
Hope that helps - pls rate the post if it does.
Paresh
03-05-2006 06:57 PM
Is it simply configure the port role to "switch" and the port will become dot1q trunk?
Besids, is there command line interface for configure the switch?
Thanks.
C.K.
03-05-2006 07:08 PM
Yesh, set up the port role to switch to make it a trunk.
Unfortunately, the CE500 series switches cannot be managed through a CLI - you have to use CNA.
Hope that helps - pls rate the post if it does.
Paresh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide