Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is Ios 11.1 compatible with Pix??

my Setup

Pix (NAT)---------(e0) router 2500 (s0)--Internet

The router 2500 is running ios 11.1. Is 11.1 compatible with Pix.Because i can`t get my internal host to connect the internet(the same was working with cisco 2600,ios 12.3)


Re: Is Ios 11.1 compatible with Pix??

It shouldn't be an IOS issue. But you changed both hardware (router) and IOS. When doing this you may have lost some functionality. Can you post sh ver and sh run of both old and new configuration.

New Member

Re: Is Ios 11.1 compatible with Pix??

Yeah you are right,it wasn`t ios issue. The restart of pix solved the problem.

Sorry just a quick check

ip nat outside source static

Can both(inside and outside network) initiate traffic to specified host.Or should I have one seperate for inside.

Re: Is Ios 11.1 compatible with Pix??

This NAT entry is static, therefore it'll always be in NAT table (you can check with sh ip nat translation). And from both sides traffic can be initiated.