Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
260
Views
0
Helpful
2
Replies

Is IP routing the same as enable in CNA?

wrwiii122
Level 1
Level 1

‎07-31-2006 07:34 AM - edited ‎03-03-2019 04:18 AM

Is the command ip routing in the CLI the same as routed enable, using Cisco Network Assistant, on the IP address page under device properties? By default it is enabled for the Vlans that I have IP addresses for but I dont see ip routing in the config but I can route if my gateway is set to that device. When I uncheck it I can no longer route between the two networks.

Labels:
0 Helpful
2 Replies 2

Anand Narayana
Level 6
Level 6

‎07-31-2006 07:55 AM

yeah it is normal. routed enable is equal to ip routing in CLI.

hope this helps.

rate this post.

0 Helpful

wrwiii122
Level 1
Level 1
In response to Anand Narayana

‎07-31-2006 08:11 AM

But why doesnt it put ip routing in the running config then? I did a little more research and the enable routed is considered a SVI. hmmmmmmm

0 Helpful
Customers Also Viewed These Support Documents